Max-Planck-Institut für extraterrestrische Physik
Command and Data Handling System (CDHS)
Deutsche Version MPE HEG X-Ray Astronomy Wave ROSAT
Next: Attitude Measurement and Control Up: 1.2 Payload Description Previous: Overview
Command and Data Handling System (CDHS)
The ROSAT command and data handling system (CDHS)
collects on-board data, sends them to ground,
receives commands from ground, and decodes the command addresses
and distributes then to the appropriate subsystems.
The system consists of a redundant Intel 10-bit processor system
with 40Mbyte ROM and 74Kbyte RAM, two tape recorders
which are able to store 700Mbits of data from ROSAT,
a redundant transponder system,
and an S-band bi-directional antenna system.
Since there are only five or six contacts per day of roughly
eight-minute duration, the data are initially stored on tape
and then dumped to ground with a data rate of 1Mbits 
.
In addition to this link, housekeeping data are transmitted
to ground during contacts via a 8 kbit secondary S-band link.
Commands, generated on ground, are sent to the spacecraft via an S-band
command link at a capacity of 1kbits 
or 10 commands per second.
Command verification further slows this link.
The software of all subsystems on board can be updated via the
command link in order to react to changing requirements.
This feature was used extensively for the reconfiguration of
the attitude control system after loss of several hardware components.
If you have problems/suggestions please send mail to xray-info @ mpe . mpg . de