PARSEC & the LGSF are in operation


PARSEC, a joint project by MPE (Garching) and MPIA (Heidelberg), is a sodium line laser which can produce a high quality 12W continuous wave output beam. It is currently installed on Yepun, the fourth 8.2-m unit telescope of the VLT in Chile, as part of the Laser Guide Star Facility. The aim of the LGSF is to substantially increase the sky coverage available to, and hence the scientific potential of, the adaptive optics cameras CONICA (with NAOS) and SPIFFI (as part of SINFONI). This has been achieved as a collaborative effort between the Max Planck Institutes and the European Southern Observatory (who were responsible for the laser clean room, the beam relay, and the launch telescope).

First Light
  external link MPG press release (in German)
  externer Verweis ESO press release
    First Science
  external link MPG press release (in German)
  externer Verweis ESO press release

see also   externer Verweis ESO press photo of the laser pointing to the Galactic Center


The LGSF has been run successfully in both service and visitor modes and has provided Strehl ratios in excess of 20% in the K-band. Operation of the laser is totally transparent to the observer. During the afternoon it is started up by a Laser Specialist. Then when observing begins, the Telescope Instrument Operator takes over. During the night the TIO uses a control panel to make sure that the laser continues to run smoothly so that it is available whenever it is needed. The Night Astronomer, who runs the camera and adaptive optics system, coordinates with the TIO when the laser guide star is needed for observations. And the observer can just sit back and acquire high resolution data.

PARSEC (without cover) a few months before the European acceptance test in 2004

Photos of the PARSEC laser system (right), and of the power meter (above) showing the highest single mode 589nm power that has been achieved. Triplet quenchers were used to reach this output level; normally they will be not be used, limiting the output to about 17W.

During the development stages of PARSEC

Photos of the power meter (above) and of the prototype laser system (right) during the Laser Selection Test in March 2002. At this stage we were still using a 70W Argon ion laser to pump the amplifier.

Links to related projects

  link ALFA- the laser guide star adaptive optics project built by MPE/MPIA for the 3.5-m telescope at Calar Alto, Spain

  link CONICA- the first VLT AO science camera, which will be used the the NAOS adaptive optics system

  link SPIFFI - an integral field spectrometer for the VLT which will be used with the MACAO adaptive optics system