Technical Equipment

In the thermal vacuum chambers technical assemblies can be tested under vacuum conditions, components outgassed and residual gas analysis and various leak tests performed.

Thermal vacuum Chamber I

Technical assemblies can be tested under vacuum conditions and simultaneous thermal stress in this thermal vacuum Chamber. For example the thermal environment inside a satellite structure can be simulated.

Thermal vacuum Chamber II

This thermal vacuum Chamber significantly helps to outgas assemblies, cables, plastic elements, etc. This should prevent cleaner environments from contaminated with condensable materials during operation or further testing.
Vacuum Chamber III

Vacuum Chamber III

This small vacuum Chamber is used for the verification of pressure gauges, mass spectrometers for the analysis of residual gas, or various leak tests.

Thermal vacuum Chamber IV

This thermal vacuum Chamber significantly helps to outgas assemblies, cables, plastic elements, etc. This should prevent cleaner environments from contaminated with condensable materials during operation or further testing.

Thermal vacuum Chamber V

Technical assemblies can be tested under vacuum conditions and simultaneous thermal stress in this thermal vacuum Chamber. For example, the thermal environment inside a satellite structure can be simulated.

Vibration test facility

Loads are simulated on the vibration test facility, which occur during take-off or during transportation.

Climate Chamber

In the climatic Chamber, assemblies can be tested under thermal and climatic stresses.
Web-View
Print Page
Open in new window
Estimated DIN-A4 page-width
Go to Editor View